ADRIENNE CALL ARTISAN
Playmakers Repertory Company
Prop Master Andrea Bullock
Props Artisan 2016 - 2018
A brazing project in which I used spoons and forks to create a rose. 2019
This steel strap cube was welded together using both TIG welding and Gas welding. 2019
The Life of Galileo 2019
Temples of Lung and Air 2018 Wall of boomboxes and speakers that I had to cut the backs off of and gut completely of their electronics to light from behind.
Radio wall in the making. After setting them out on the floor I attached them together in smaller sections to make them more easily moved and attached together later.
Temples of Lung and Air 2018 Finished wall in the space.
Temples of Lung and Air 2018
Leaving Eden 2018 Set Designer Jan Chambers Arcylic Paint on Lauan
Set Designer Alexis Distler
The Christians 2018 Set Designer Alexis Distler Beginning stages of the build
The Christians 2018 Set Designer Alex Distler
The Christians 2018 Set Designer Alexis Distler Finished podium on left. The detail on the front (right) was originally too big in both height and width and had to be cut down and look seamless in its reattachment.
Dot 2017 Set Designer Mckay Coble
The Cake 2017 Set Designer Jan Chambers The cakes on top are fake cakes: Red Velvet and Pink Lemonade. The bottom cakes were real ones I had to make and decorate for show consumables throughout the run.
The Cake 2017 Set Desinger Jan Chambers
The Cake 2017 Set Designer Jan Chambers
The Cake 2017 Set Designer Jan Chambers
Bye, Bye, Birdie 2017 Set Designer Andrea Ball
Intimate Apparel 2017 Set Designer Georgia Lee
Intimate Apparel 2017 Set designer Georgia Lee Spinet piano had to be made to look like an upright piano.
Intimate Apparel 2017 Set Designer Georgia Lee
Intimate Apparel 2015 Set Designer Georgia Lee
The Crucible 2016 Set Designer Narelle Sissons Table on left was original table and in order to fit on our trap with the other furniture we needed to make it smaller. So I took it apart, built a new top and cut new sides.
The Crucible 2016 Set Designer Narelle Sissons
Lathe Project 2017
Bandsaw Porject 2017 Design was required to change slightly when I used too large of a bandsaw blade and cut a curve too large.
Everything was bent with a Hossfeld Bender and then I tack welded it from the back.
Scrollsaw Project 2017
Welding Project 2017